Quick and easy tool positioning Locating rings are mounted on the mould to assist with the positioning of the tool in the injection moulding machine. Thus, the positioning, centring and fastening of the complete tool to the platens of the...

Homogeneous cooling The cycle time is an essential factor for the economical production of plastic parts. This in turn is heavily dependent on an optimal mould temperature and reacts very sensitively to even the smallest changes. This is...

NEW: Ø10 mm New at KNARR: As a supplement to the previous range (Ø13 mm, Ø16 mm, Ø19 mm, Ø22 mm, and Ø28 mm), KNARR now offers the slide holding device with roll also in Ø10 mm. This type of slide retainer provides obvious advantages:An...

Now with DLC coating Different types of centring elements provide exact alignment of the mould halves. Thus, the risk of later flashes on the plastic part is minimized. With many years of manufacturing expertise of centring elements, it is not...

The newly standardized, space-saving head shape of the ejector pin ensures its distinct position in the tool. Different surfaces on both sides  allow mounting only in the exactly desired position and prevent the distortion of the ejector at...

Right and left hand versions It looks the same as always – and yet it has a decisive added value. With the new cycle counter, KNARR combines the traditional design with a significantly higher temperature resistance. Instead of the...