The next generation of venting Mould optimisation through cavity venting Often, air or gasses are produced during the injection moulding process that must not be trapped in the cavity under any circumstances. Otherwise, cavities are created which...

Slide- and guide rails Two new types of slide rails available As a useful complement to the extensive range of slide rails, KNARR standardises maintenance-free, self-lubricating slide rails. The embedded graphite inserts provide the necessary...

Sprue holding pins New types available Regardless of the type of sprue holding pin used, there is a standardised undercut at the end of the shaft. With its help, the solidified plastic is retained in the sprue runners. This ensures that the sprue...

Positioning wedges Easy positioning of the mould insert In the case of moulds with interchangeable inserts, positioning wedges ensure high-precision installation positioning and at the same time allow the necessary clearance for easier installation...

Highly corrosion resistant Traditionally, the topic of “cooling and temperature control” plays an important role. After all, the right mould temperature control is crucial in terms of quality and efficient production of plastic parts....

Guide also as blank version Standardized slanted slide units help with the implementation of complex mould part geometries, minimize the in-house production effort and ensure quick replacement in the event of damage or wear. Slanted slide...